fizbim
11-18-2002, 05:52 PM
I have used the Blaze router a few times.
Even though it routes the board to 100%, it looks like crap. Pads PCB is setup for strict pad entry exit (90 degree), but Blaze seems to ignore it. Blaze routes into surface mount pads at all different entry/exit angles causing manufacturing issues.
How do I get Blaze to obey the routing rules from Pads ?
Thankss
Even though it routes the board to 100%, it looks like crap. Pads PCB is setup for strict pad entry exit (90 degree), but Blaze seems to ignore it. Blaze routes into surface mount pads at all different entry/exit angles causing manufacturing issues.
How do I get Blaze to obey the routing rules from Pads ?
Thankss