Exceeded routing layer limits?

[Pin]

Hi, experts here,

I'm a new user of PowerPCB and a beginner of PCB design.
I'm designing a simple test board. When I finished the parts placement and lanched BlazeRouter to autoroute, I got following error message from Blaze, "You have exceeded routing layer limits-- routing commands disabled". What's wrong? What could I do now?

Thanks in advance,

Pin

[randychase]

What is the layering of the pcb? How many layers are set (enabled) to be routing layers?

Look at SETUP then LAYER DEFINITION.

[Pin]

Thank you very much!

I just found out that my software has two routing layer limitation and I set all the four layers to be routing layer. That's the reason!

Thanks again.