orcad to Viewlogic

[Carl_at_xrite]

help!!!
I have been asked to re-do a project from orcad to Pads via Viewlogic schematic.
Is there anyway at all to grab an orcad schematic and bring it into Viewlogic?
I know I can do this through Protel but viewlogic seems to be a real problem as far as compatability to other platforms..
thanks,
Carl

[Lameris]

The supported method is through EDIF. I would work with Tech Support on it.

[Edward Couch]

EDIF does a so so job. Because Orcad does not output EDIF well, I have translators that do the Job though.

[jthomas]

Mentor Graphics is working on an actual translator for this, and they are supposed to have it ready for the trade show this March up in San Jose.