Moving Parts And Traces

[LANZ]

Can someone please tell me how to move parts (symbols) and traces (connect lines) at the same time in 16.0???

It took me forever to figure out how to turn off ripup etch so any traces didn't automatically get deleted, but I still can't seem to highlight and move both at the same time.

Thanks for any help you can give!

[amd.singh]

You can select both of these from the Find filter. Run the move command and in the find filter check mark the boxes "Symbols", "clines". Under the Options tab select "Stretch Etch". Now drag your mouse to select the clines and symbols and move them.

[LANZ]

You can select both of these from the Find filter. Run the move command and in the find filter check mark the boxes "Symbols", "clines". Under the Options tab select "Stretch Etch". Now drag your mouse to select the clines and symbols and move them.

Worked perfectly...THANKS SO MUCH!!!

It is such a basic function, that I was going crazy not being able to figure it out. I never use the find box, I just thought it was for finding parts and such.

Thanks again.

Lance