rdawson
11-16-2007, 06:48 AM
Hi all,
I'm looking for some documentation on using the DXF translator in command line mode. I'm trying:
MAXDXF file1 file2 file3 and the GUI comes up as you would expect with the input, output and .ini file fields filled in. how do you set the switches?
I do a lot of conversions and would like to batch this application.
Thanks,
Randy Dawson
I'm looking for some documentation on using the DXF translator in command line mode. I'm trying:
MAXDXF file1 file2 file3 and the GUI comes up as you would expect with the input, output and .ini file fields filled in. how do you set the switches?
I do a lot of conversions and would like to batch this application.
Thanks,
Randy Dawson