Block move

[eo1668]

Hi,
I am trying to move a section of the layout to another location, the problem is that when I select the block (with parts & traces) to move, some of the traces (esp. vcc & gnd) seems to stay at the original location and the traces after move is in a mess and need a long time to tidy up.
Is there a better way that I can move the parts and traces together without mess up the routing.

Thanks.

[randychase]

Depends.. but try this.

SETUP, PREFERENCES, DESIGN

Unclick the box that says Stretch Traces During Component Move.

You might also want to change the setting for Group Editing, Include Traces Not Attached.