Carl_at_xrite
02-20-2002, 12:41 PM
Bug PADS 4.0 1!!!
I recently worked on a multilayer board that incorporated some free pads.
These pads somehow got echoed or mirrored into other locations on the board.
Pads did not see them as components but the planes cleared around them.
They also did not show up in drc reports or component/part list reports.
these only showed up in the CAM output preview or in the plots.
the only way to get rid of them was to ascii out the board and then ascii back in.
So... watch your artwork !!!!
I recently worked on a multilayer board that incorporated some free pads.
These pads somehow got echoed or mirrored into other locations on the board.
Pads did not see them as components but the planes cleared around them.
They also did not show up in drc reports or component/part list reports.
these only showed up in the CAM output preview or in the plots.
the only way to get rid of them was to ascii out the board and then ascii back in.
So... watch your artwork !!!!