cfan
01-22-2005, 05:54 PM
Hi friends,
I have a small 4-layer board that requires to use both "through" and "partial" vias. When generating the CAM files for manuafacturer, only the "through" vias displayed the partial vias are missing in the NC-Drill data. When editing the "NC-Drill" Document, I can't check the the "partial vias" option.
Do I miss anything in setup?
The data I have like this:
NC Drill (Plated Pins, Non-Plated Pins)
Through vias;
Please help
I have a small 4-layer board that requires to use both "through" and "partial" vias. When generating the CAM files for manuafacturer, only the "through" vias displayed the partial vias are missing in the NC-Drill data. When editing the "NC-Drill" Document, I can't check the the "partial vias" option.
Do I miss anything in setup?
The data I have like this:
NC Drill (Plated Pins, Non-Plated Pins)
Through vias;
Please help