TestPrep

[peter408]

I have used testprep a few times and no problems. I have an smt pad and a through hole pad to replace vias. Again I have used these before. Tesprep will not run and I get an error 105009. I have found nothing on SourceLink. Any thoughts?

Never mind. I turned off auto-insertion and the error went away. I am switching to 15.2 next month. Has anyone run testprep in 15.2? Just checking for problems ahead of time.

[cadpro2k]

Hi Peter,

I don't see the Testprep function getting much attention, so I don't think it's been messed with (i.e. changed --> broken).

I hope you find this to be the case. Best of luck in 2005 with v15.2

Good day.

Mitch

[may]

I've used testprep with 15.2 many times.It's very convenient and helpful,either replacing via with through hole or smd pad.
you can try it .