RF Design

[Facundo]

Hi all, I'm from Argentina, and Ihave a problem with RF design.

I must do a 2.9mm width track, and its finish in .3mm in the same segment.

If Somebody know, please answer me.

Thanks to everyone

[Skip Yutkus]

It sounds like you need a 0.115" wide trace with a 1 Oz thickness, (.0012"). That sounds normal to me am I missing something?

Skip

[Facundo]

Yes that's right, but i need pass from 2.9mm to .3mm in the same segment and i don't know how.

Facundo

Sorry for the english.

[qrk]

You need to use a copper pour to make tapered traces. You can run a trace into the copper pour or have it touch the pads of your devices. Be sure to set "do not fill beyond obstacle edge". Makes setting the widths much easier.

[Skip Yutkus]

Stupid calculator - it said .3mm was .0012 it's really .012 - never mind! LOL

Skip

[Facundo]

Thanks a lot. And sorry for response so later.

Greeting.