How to include +3.3V in schematic ? [Archive]

View Full Version : How to include +3.3V in schematic ?

ayeong

02-09-2003, 01:12 AM

Hi,

Currently, I'm using PowerLogic v5.0.

During schematic entry, I would like to connect several pins to the VCC. However, when I use "Ctrl+tab" to cycle through the power connections, +3.3V is not available in there.

So I decided to create one by modifying their main library to included +3.3V. However, I still could not get it included in.

Anybody got any idea ?

Thanks

H.Tikkanen

02-09-2003, 01:37 AM

Try selecting Tools-Update Off Page-Update Power.

Also, it is a good idea to leave the net name in one of the arrow symbols blank. When this is selected, PowerLogic always asks for the net name (and sets it visible).

H.Tikkanen

ayeong

02-09-2003, 03:25 PM

Thanks a million ! It works.

Perhaps I was a little bit careless.

Best Regards
Andy