Micro Vias

[noandy]

Does any one know if Layout Plus can handle microvias (4mm) in a pad and only going down two or three layers. If I utitilize the drill in the padstack it will go through the entire board. This is not what I want.
The soloution would also apply to a buried via.

[SpeedyG]

NoAndy,

You need to assign a different VIA type. You need to make sure that the via type has pads or clearances on all layers that it is to pass through. Once your pads are made up, it should work just fine.

Good Luck.

Ralph