Component Missing From Netlist

[Bruce Allred]

I am working on my first PowerLogic/PowerPCB design.

All of the parts in the schematic showed up properly in the *.asc netlist, except for the parts representing non-plated mounting holes.

I have created these as parts using a gate with no pins, and a PCB decal with one pin. Pin one pin shows up in the unused pins list. There are, of course, no connections on the schematic

Does anyone have any suggestions?

Thanks,
Bruce.

[H.Tikkanen]

PowerLogic 4 and 5 have capability to recognize a part which has no pins as non-electrical. By default it is not transferred to PCB. You can adjust this in Setup-Preferences-Design tab.